![]() This does not happen with old protocol software. The network watchdog setting makes no difference. Receiver 2 which is connected to ADC2 (RX2 port) works fine. No antenna signal is seen from any (antenna) port. When I stop Thetis, disconnect the Ethernet port (relay(s) click), reconnect the Ethernet port and start Thetis again then the antenna port for ADC1 is disconnected. Loosing input port connection to ADC1 when the Ethernet cable is momentarily disconnected This does not happen with old protocol software"" When Thetis is re-started it has the old settings. TX-VFO B works fine with VAC2 This does not happen with old protocol software""Ĭhanges in Setup-General-ADC are not saved TX-VFO A does not see TX audio from VAC1 when VAC2 is also enabled There is a pulse while running ESSB that is random, not on SSBĮSSb, that changing from 3.6k to 6k or 8k or whatever other ESSB profile that transmitted bandwidth does not change in transmit Sporadic cracking when WB is disabled disappears when hardware is powered down and up again.Ģ*384K with WB => CPU UI=9% CPU task manager=13% Ethernet Receive=53.1Mb/sĢ*1536Kwithout WB => CPU UI=16% CPU task manager=21% Ethernet Receive=154Mb/s Problems disappear or diminishes when WB is disabled, even when sample rate on both receivers is increased to 1536000 Not serious, but confusing.Ĭracking sound, in particular when WB is enabled at sample rate 384000 and up for both receiversĪlso seq>DDC2 errors but not necessarily consistent with cracking sound With Alex disabled Antenne Control is not possible. You'd think that was S-W but, I checked the code and I believe the software is operating per the protocol documentĮxcepton which is thrown if I try to activate VAC1 or VAC2Īnswer: If you have the VAC input device set to the computers microphone and it is set as auto detect when the mic is plugged in you will need to disable the auto detect feature.ĭefaults for ANAN100D has Alex disabled, should be enabled. ![]() ![]() Tip-Ring MIC selection is reversed in General/Hardware Config Menu (and apparently it was working correctly with old protocol firmware) This list is moderated and the error will be added once it is checked by our administrators. New Protocol Beta Test Reported Error List ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |